View source for OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI

Dalam salah satu contoh compile firmware di bagian sebelumnya adalah firmware OpenWRT yang sengaja di compile tanpa HTTP dan LuCI. Akibatnya, firmware tersebut jadi sangat ringan karena di operasikan tanpa WebGUI. Konfigurasinya sebetulnya relatif sederhana juga. Secara umum langkah yan perlu di lakukan ada empat (4) yaitu,

* Aktifkan Wifi menjadi adhoc network.
* Set IP address agar statik
* Set /etc/olsrd.conf
* Edit /etc/rc.local agar olsrd jalan dengan baik.


==Aktifkan WiFi==

Untuk mengaktifkan Wifi kita perlu mengedit,

 vi /etc/config/wireless

Masukan 

 config wifi-device  radio0
         option type     mac80211
         option channel  1
         option macaddr  00:15:6d:da:ec:d1
         option hwmode   11g
         option antenna  auto
         option diversity 0
         option txpower  15 
         option disabled 0

 config wifi-iface
         option device   radio0
         option network  mesh
         option mode     adhoc
         option ssid     MESH
         option encryption none
         option bssid    02:CA:FF:EE:BA:BE


Biasanya di konfigurasi awal /etc/config/wireless ada kata-kata

 # REMOVE THIS LINE TO ENABLE WIFI:
 option disabled 1

Ubah menjadi option disable 0

==Konfigurasi IP address Wireless==

Edit konfigurasi IP address untuk wireless,

 vi /etc/config/network

Masukan

 config interface mesh
        option ifname   wlan0
        option type     bridge
        option proto    static
        option ipaddr   172.16.123.12
        option netmask  255.255.0.0

restart network

 /etc/init.d/network restart

cek di console apakah sudah operasional dengan baik, ketik perintah


 iwconfig 

akan keluar kurang lebih

 wlan0     IEEE 802.11bg  ESSID:"MESH"  
           Mode:Ad-Hoc  Frequency:2.412 GHz  Cell: 02:CA:FF:EE:BA:BE   
           Tx-Power=15 dBm   
           RTS thr:off   Fragment thr:off
           Encryption key:off
           Power Management:on
         
==Konfigurasi OLSR==

Edit konfigurasi olsrd

 vi /etc/olsrd.conf

Masukan

 Hna4
 {                     
 } 
 Hna6  
 {                                                    
 }
 LoadPlugin "olsrd_txtinfo.so.0.1"
 {
     PlParam  "accept" "0.0.0.0"                                              
 } 
 InterfaceDefaults  
 {                        
 }
 Interface "wlan0" "eth0" "br-lan"
 {
      Mode "mesh"
 }

==Masukan rc.local==

masukan ke /etc/rc.local

 ifconfig wlan0 172.16.123.12
 /etc/init.d/olsrd stop
 rm /var/run/olsrd-ipv4.lock 
 olsrd -f /etc/olsrd.conf &

==reboot==

Selesai sudah proses konfigurasi UBNT NanoStation2 agar menjadi Mesh Node, kita perlu me-restart menggunakan perintah

 reboot

==Pranala Menarik==

* [[OpenWRT]]
* [[OpenWRT: Download Firmware yang sudah jadi]]
* [[OpenWRT: Source Repository Download]]
* [[OpenWRT: Melihat Daftar Package]]

===Build Firmware===

* [[OpenWRT: Build Firmware]]
* [[OpenWRT: Build Firmware Download Source Pendukung]]
* [[OpenWRT: Build Firmware Buffalo WZRHPG450H]]
* [[OpenWRT: Build Firmware Buffalo WZRHPG300N]]
* [[OpenWRT: Build Firmware Buffalo WZRHPG300NH2]]
* [[Buffalo]]
* [[Buffalo: WZRHPG450H Cara Recovery]]
* [[Buffalo: WZRHPG450H OpenWRT mengaktifkan setelah di flash]]
* '''[[Buffalo: WZRHPG450H Membuat Firmware OpenWRT Sendiri]]''' '''RECOMMENDED'''
* [[Buffalo: WZRHPG450H OpenWRT instalasi aplikasi Pendukung OLSRD]]
* [[OpenWRT: Build Firmware Ubiquiti NanoStation2]] '''RECOMMENDED'''
* [[OpenWRT: Build Firmware Ubiquiti NanoStationM2]] '''RECOMMENDED'''
* [[OpenWRT: Build Firmware Mikrotik RB433]]
* [[OpenWRT: Build Firmware Linksys WRT160NL]]
* [[OpenWRT: Build Firmware Linksys WRT54GL]]

===APRX===


* [[OpenWRT: Build Firmware Buffalo WZRHPG300NH2 untuk APRX]]

===IPv6===

* [[OpenWRT: IPv6]]
* [[OpenWRT IPv6: Build Firmware Linksys WRT160NL]]
* [[OpenWRT IPv6: Build Firmware Linksys WRT160NL Tanpa WebGUI]]
* [[OpenWRT IPv6: Build Firmware Buffalo WZRHPG450H]]
* [[OpenWRT IPv6: Build Firmware Buffalo WZRHPG300NH2]]
* [[OpenWRT IPv6: Setup tunnel ke tunnelbroker]]
* [[OpenWRT IPv6: Konfigurasi]]
* [[OpenWRT IPv6: Konfigurasi WAN6 dengan radvd]]

===Flash Firmware===

* [[OpenWRT: Flash Linksys WRT54GL]]
* [[OpenWRT: Flash Linksys WRT160NL]]
* [[OpenWRT: Flash Buffalo WZRHP450H]] '''RECOMMENDED'''
* [[OpenWRT: Flash Buffalo WZRHP300N]]
* [[OpenWRT: Flash UBNT NanoStation2]] '''RECOMMENDED'''
* [[OpenWRT: Flash UBNT NanoStation M2]] '''RECOMMENDED'''
* [[OpenWRT: Flash UBNT NanoStation Loco M2]]
* [[OpenWRT: Flash UBNT Bullet M2]] '''RECOMMENDED'''
* [[OpenWRT: Flash Mikrotik RB433]] '''RECOMMENDED'''
* [[OpenWRT: Flash Mikrotik RB450]]

===Misc===

* [[OpenWRT: Setup WiFi]]
* [[OpenWRT: Setup PPTP VPN Server]]
* [[OpenWRT: Setup OLSR di UBNT via CLI]] '''RECOMMENDED'''
* [[OpenWRT: Mikrotik RB433]]
* [[OpenWRT: Setup OLSR Sederhana]]
* [[OLSR - di OpenWRT]]
* [[OpenWRT: 3G modem]]
* [[OpenWRT: Build Firmware dengan 3G Modem Support]]
* [[OpenWRT: Setup Firewall]]
* [[OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI]]

===UBNT===

* [[UBNT]]
* [[UBNT: Teknik Recovery]]
* [[UBNT: Upload Firmware]]
* [[UBNT: Rebuild Firmware]]
* [[UBNT: firmware dengan OLSR]]
* [[UBNT: openwrt]]
* [[UBNT: olsr dengan openwrt]]
* [[UBNT: olsr dengan kamikaze openwrt]]
* [[UBNT: olsr dengan backfire openwrt]] '''RECOMMENDED'''
* [[UBNT: UniFi]]
* [[UBNT: UniFi Konfigurasi Awal]]
* [[UBNT: UniFi Manajemen HotSpot]]
* [[UBNT: OLSR Pembuatan Firmware]]
* [[UBNT: OLSR Konfigurasi]]
* [[OLSR - di UBNT]]
* [[OLSR - di Ubuntu]]
* [[OpenWRT]]
* [[OLSR: NAT di UBNT dengan OLSR]]