View source for OpenWRT IPv6: NAT64 dan DNS64

NAT64/DNS64 on OpenWRT

The latest stable release of OpenWRT – Barrier Break – makes it a simple matter to add NAT64 and DNS64 capabilities to the router. This is particularly useful if one wishes to run an IPv6 only internal LAN network while dealing with the IPv4 + IPv6 world of the Internet.
DNS64

DNS64 provides a faux AAAA record for any existing A record. The easiest tool to use for this is TOTD, which is no longer in development but is found in the main OpenWRT repositories.

So, install TOTD and configure it.

 # opkg update
 # opkg install totd
 # vi /etc/totd.conf

The totd.conf file should contain the following:

 ; substitute with your upstream DNS
 forwarder 8.8.8.8 port 53
 forwarder 8.8.4.4 port 53
 ; modify your OpenWRT ULA prefix here
 prefix fd63:fab9:6ccf:64::
 ; this port is used later
 port 5353

Enable and start TOTD, and check the logs for any errors:

 # /etc/init.d/totd enable
 # /etc/init.d/totd start
 # logread

Finally, configure the built-in DNSMASQ to use TOTD as its upstream. Just remember to use 127.0.0.1#5353 as the upstream server. Note the use of a hash (#) symbol.

You should be able to verify that it works by querying AAAA records for pure IPv4 names. You should see that a fake IPv6 address be returned with your TOTD specified prefix.

 # ping6 ipv4.google.com

You won’t be able to actually ping it over IPv6 yet at this point, until your NAT64 is setup correctly.
NAT64

NAT64 provides an IPv6 to IPv4 NAT mechanism which will actually transfer the IPv6 packets by converting them into IPv4 packets and back. The tool to do this is TAYGA and is also available in the OpenWRT repositories.

First, install TAYGA.

 # opkg update
 # opkg install tayga

Next, edit /etc/config/network and add a new interface.

 config interface nat64
  option proto tayga
  option ifname 'tayga-nat64'
  option ipv4_addr 192.168.64.1
  option prefix fd63:fab9:6ccf:64::/96
  option dynamic_pool 192.168.64.0/24
  option accept_ra 0
  option send_rs 0

Next, edit /etc/config/firewall and add it to the LAN zone.

 config zone
  option name 'lan'
  option input 'ACCEPT'
  option output 'ACCEPT'
  option forward 'ACCEPT'
  option network 'lan nat64'

Enable and start TAGYA, and check the logs for errors.

 # /etc/init.d/network restart
 # /etc/init.d/firewall restart
 # logread

You should now be able to ping any IPv4 server using IPv6.

 # ping6 ipv4.google.com

Voila!


==Referensi==

* http://tech.sybreon.com/2015/05/05/nat64dns64-on-openwrt/