Arduino: Blink - Revision history

Onnowpurbo: /* Source Code */

2018-12-25T08:51:19Z

Source Code

← Older revision		Revision as of 08:51, 25 December 2018
Line 47:		Line 47:

	Coba ubah nilai delay, misalnya menjadi 300 dsb. Lihat effek-nya terhadap kedipan LED.		Coba ubah nilai delay, misalnya menjadi 300 dsb. Lihat effek-nya terhadap kedipan LED.


			==Pranala Menarik==

			* [[Arduino]]

Onnowpurbo: /* Hardware */

2015-11-16T21:42:57Z

Hardware

← Older revision		Revision as of 21:42, 16 November 2015
Line 3:		Line 3:
	* Arduino UNO		* Arduino UNO

	Di Arduino UNO, pin nomor 13 sudah tersambung ke LED sehingga dapat langsung mempraktekan		Di Arduino UNO, pin nomor 13 sudah tersambung ke LED sehingga dapat langsung mempraktekan tanpa perlu menambahkan hardware apapun.


	==Rangkaian==		==Rangkaian==

Onnowpurbo: /* Source Code */

2015-11-16T21:42:26Z

Source Code

← Older revision		Revision as of 21:42, 16 November 2015
Line 44:		Line 44:
	delay(1000); // wait for a second		delay(1000); // wait for a second
	}		}



			Coba ubah nilai delay, misalnya menjadi 300 dsb. Lihat effek-nya terhadap kedipan LED.

Onnowpurbo: New page: ==Hardware== * Arduino UNO Di Arduino UNO, pin nomor 13 sudah tersambung ke LED sehingga dapat langsung mempraktekan ==Rangkaian== thumb ...

2015-11-16T21:41:29Z

New page: ==Hardware== * Arduino UNO Di Arduino UNO, pin nomor 13 sudah tersambung ke LED sehingga dapat langsung mempraktekan ==Rangkaian== center|200px|thumb ...

New page

==Hardware==

* Arduino UNO

Di Arduino UNO, pin nomor 13 sudah tersambung ke LED sehingga dapat langsung mempraktekan

==Rangkaian==

[[Image:ExampleCircuit bb.png|center|200px|thumb]]

[[Image:ExampleCircuit sch.png|center|200px|thumb]]

==Source Code==

/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.

Most Arduinos have an on-board LED you can control. On the Uno and
Leonardo, it is attached to digital pin 13. If you're unsure what
pin the on-board LED is connected to on your Arduino model, check
the documentation at http://www.arduino.cc

This example code is in the public domain.

modified 8 May 2014
by Scott Fitzgerald
*/

// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 13 as an output.
pinMode(13, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
digitalWrite(13, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(13, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}