Unknown user: /* Code */

2022-02-08T22:55:37Z

Code

← Older revision		Revision as of 22:55, 8 February 2022
Line 50:		Line 50:


			==Code Indonesia==

			/*
			DigitalReadSerial
			Baca digital input di pin 2, print hasil ke serial monitor
			*/

			// digital pin 2 di sambungkan ke pushbutton
			int pushButton = 2;

			void setup() {
			// initialisasi serial communication pda 9600 bits per second:
			Serial.begin(9600);
			// set pushButton pin sebagai input
			pinMode(pushButton, INPUT);
			}

			void loop() {
			// baca input pin:
			int buttonState = digitalRead(pushButton);
			// print kondisi pushButton
			Serial.println(buttonState);
			delay(1); // delay antar reads
			}

	==Referensi==		==Referensi==

	* https://www.arduino.cc/en/Tutorial/DigitalReadSerial		* https://www.arduino.cc/en/Tutorial/DigitalReadSerial

Onnowpurbo: New page: Sumber: https://www.arduino.cc/en/Tutorial/DigitalReadSerial ==Hardware Required== * Arduino or Genuino Board * A momentary switch, button, or toggle switch * 10k ohm resistor * hook-up...

2015-12-04T02:34:32Z

New page: Sumber: https://www.arduino.cc/en/Tutorial/DigitalReadSerial ==Hardware Required== * Arduino or Genuino Board * A momentary switch, button, or toggle switch * 10k ohm resistor * hook-up...

New page

Sumber: https://www.arduino.cc/en/Tutorial/DigitalReadSerial

==Hardware Required==

* Arduino or Genuino Board
* A momentary switch, button, or toggle switch
* 10k ohm resistor
* hook-up wires
* breadboard

==Rangkaian==

[[Image:Button.png|center|200px|thumb]]

[[Image:Button sch.png|center|200px|thumb]]

==Code==

/*
DigitalReadSerial
Reads a digital input on pin 2, prints the result to the serial monitor

This example code is in the public domain.
*/

// digital pin 2 has a pushbutton attached to it. Give it a name:
int pushButton = 2;

// the setup routine runs once when you press reset:
void setup() {
// initialize serial communication at 9600 bits per second:
Serial.begin(9600);
// make the pushbutton's pin an input:
pinMode(pushButton, INPUT);
}

// the loop routine runs over and over again forever:
void loop() {
// read the input pin:
int buttonState = digitalRead(pushButton);
// print out the state of the button:
Serial.println(buttonState);
delay(1); // delay in between reads for stability
}

==Referensi==

* https://www.arduino.cc/en/Tutorial/DigitalReadSerial

Arduino: Digital Read Serial - Revision history

Unknown user: /* Code */

Onnowpurbo: New page: Sumber: https://www.arduino.cc/en/Tutorial/DigitalReadSerial ==Hardware Required== * Arduino or Genuino Board * A momentary switch, button, or toggle switch * 10k ohm resistor * hook-up...