OpenWRT IPv6: Konfigurasi OLSR 6and4 - Revision history

Onnowpurbo: /* /etc/config/wireless */

2014-10-21T01:19:35Z

/etc/config/wireless

@@ Line 140: / Line 140: @@
           option network 'MESH'
           option ssid 'MESH'
 ==Referensi==

Onnowpurbo at 00:41, 21 October 2014

2014-10-21T00:41:47Z

Show changes

Onnowpurbo at 22:15, 11 October 2014

2014-10-11T22:15:48Z

← Older revision		Revision as of 22:15, 11 October 2014
Line 28:		Line 28:

	cocokan dengan kondisi jaringan anda :)		cocokan dengan kondisi jaringan anda :)

			==/etc/config/network==

			config interface 'loopback'
			option ifname 'lo'
			option proto 'static'
			option ipaddr '127.0.0.1'
			option netmask '255.0.0.0'

			config interface 'lan'
			option ifname 'eth0'
			option type 'bridge'
			option proto 'static'
			option ipaddr '192.168.1.1'
			option netmask '255.255.255.0'
			option ip6assign '60'
			option ip6prefix '2001:222:222:2::/64'
			option ip6addr '2001:222:222:2::1'

			config interface 'wan6'
			option ifname '@wan'
			option proto 'dhcpv6'

			config globals 'globals'
			option ula_prefix '2001:222:222:2::/64'

			config interface 'MESH'
			option proto 'static'
			option ipaddr '10.123.123.2'
			option netmask '255.0.0.0'
			option ip6gw '2001:123:123::2'
			option ip6prefix '2001:123:123::/64'
			option ip6addr '2001:222:222::2'

			==/etc/config/wirelesss==


			config wifi-device radio0
			option type mac80211
			option channel 1
			option hwmode 11g
			option path 'platform/ar231x-wmac.0'
			option txpower '20'
			option htmode 'HT20'
			# REMOVE THIS LINE TO ENABLE WIFI:
			option disabled 0

			config wifi-iface
			option device 'radio0'
			option encryption 'none'
			option mode 'adhoc'
			option bssid '02:CA:FF:EE:BA:BE'
			option network 'MESH'
			option ssid 'MESH'


			==/etc/config/olsrd==

			config olsrd
			# uncomment the following line to use a custom config file instead:
			#option config_file '/etc/olsrd.conf'
			# option IpVersion '6and4'
			option IpVersion '4'
			option FIBMetric 'flat'
			option LinkQualityLevel '2'
			option LinkQualityAlgorithm 'etx_ff'
			option OlsrPort '698'
			option Willingness '3'
			option NatThreshold '1.0'

			config LoadPlugin
			option library 'olsrd_arprefresh.so.0.1'

			config LoadPlugin
			option library 'olsrd_dyn_gw.so.0.5'

			config LoadPlugin
			option library 'olsrd_httpinfo.so.0.1'
			option port '1978'
			list Net '0.0.0.0 0.0.0.0'

			config LoadPlugin
			option library 'olsrd_nameservice.so.0.3'
			option ignore '0'
			option latlon_file '/var/run/latlon.js'
			option hosts_file '/etc/hosts'
			option resolv_file '/etc/resolv.conf'

			config LoadPlugin
			option library 'olsrd_txtinfo.so.0.1'
			option accept '0.0.0.0'

			config Interface
			option ignore '0'
			option interface 'MESH'
			option Mode 'mesh'

			config InterfaceDefaults
			option Mode 'mesh'

			config Hna6
			option netaddr '2001:222:222:2::'
			option prefix '64'


	==Referensi==		==Referensi==

Onnowpurbo: /* Referensi */

2014-09-07T06:36:57Z

Referensi

← Older revision		Revision as of 06:36, 7 September 2014
Line 32:		Line 32:

	* https://dev.openwrt.org/ticket/4803		* https://dev.openwrt.org/ticket/4803


			==Pranala Menarik==

			* [[OpenWRT]]
			* [[OpenWRT: Download Firmware yang sudah jadi]]
			* [[OpenWRT: Source Repository Download]]
			* [[OpenWRT: Melihat Daftar Package]]
			* [[OpenWRT: Mengembalikan setting default Config.in]]

			===Build Firmware===

			* [[OpenWRT: Build Firmware]]
			* [[OpenWRT: Build Firmware Download Source Pendukung]]
			* [[OpenWRT: Build Firmware Buffalo WZRHPG450H]]
			* [[OpenWRT: Build Firmware Buffalo WZRHPG300N]]
			* [[OpenWRT: Build Firmware Buffalo WZRHPG300NH2]]
			* [[Buffalo]]
			* [[Buffalo: WZRHPG450H Cara Recovery]]
			* [[Buffalo: WZRHPG450H OpenWRT mengaktifkan setelah di flash]]
			* '''[[Buffalo: WZRHPG450H Membuat Firmware OpenWRT Sendiri]]''' '''RECOMMENDED'''
			* [[Buffalo: WZRHPG450H OpenWRT instalasi aplikasi Pendukung OLSRD]]
			* [[OpenWRT: Build Firmware Ubiquiti NanoStation2]] '''RECOMMENDED'''
			* [[OpenWRT: Build Firmware Ubiquiti NanoStationM2]] '''RECOMMENDED'''
			* [[OpenWRT: Build Firmware Mikrotik RB433]]
			* [[OpenWRT: Build Firmware Linksys WRT160NL]]
			* [[OpenWRT: Build Firmware Linksys WRT54GL]]
			* [[OpenWRT: Build Firmware untuk IPv6]]

			===APRX===


			* [[OpenWRT: Build Firmware Buffalo WZRHPG300NH2 untuk APRX]]
			* [[OpenWRT: Setup APRX]]

			===IPv6===

			* [[OpenWRT: IPv6]]
			* [[OpenWRT: mengaktifkan IPv6]]
			* [[OpenWRT IPv6: Build Firmware Linksys WRT160NL]]
			* [[OpenWRT IPv6: Build Firmware Linksys WRT160NL Tanpa WebGUI]]
			* [[OpenWRT IPv6: Build Firmware Buffalo WZRHPG450H]]
			* [[OpenWRT IPv6: Build Firmware Buffalo WZRHPG300NH2]]
			* [[OpenWRT IPv6: Setup tunnel ke tunnelbroker]]
			* [[OpenWRT IPv6: Konfigurasi]]
			* [[OpenWRT IPv6: Konfigurasi Sederhana]] '''RECOMMENDED'''
			* [[OpenWRT IPv6: Konfigurasi WAN6 dengan radvd]]
			* [[OpenWRT: Build Firmware untuk IPv6]]
			* [[OpenWRT IPv6: Konfigurasi OLSR 6and4]]

			===Flash Firmware===

			* [[OpenWRT: Flash Linksys WRT54GL]]
			* [[OpenWRT: Flash Linksys WRT160NL]]
			* [[OpenWRT: Flash Buffalo WZRHP450H]] '''RECOMMENDED'''
			* [[OpenWRT: Flash Buffalo WZRHP300N]] '''RECOMMENDED'''
			* [[OpenWRT: Flash UBNT NanoStation2]] '''RECOMMENDED'''
			* [[OpenWRT: Flash UBNT NanoStation M2]] '''RECOMMENDED'''
			* [[OpenWRT: Flash UBNT NanoStation Loco M2]]
			* [[OpenWRT: Flash UBNT Bullet M2]] '''RECOMMENDED'''
			* [[OpenWRT: Flash Mikrotik RB433]] '''RECOMMENDED'''
			* [[OpenWRT: Flash Mikrotik RB450]]

			===Misc===

			* [[OpenWRT: CLI]]
			* [[OpenWRT: Setup WiFi]]
			* [[OpenWRT: Setup PPTP VPN Server]]
			* [[OpenWRT: Setup OLSR di UBNT via CLI]] '''RECOMMENDED'''
			* [[OpenWRT: Mikrotik RB433]] '''RECOMMENDED'''
			* [[OpenWRT: Setup OLSR Sederhana]]
			* [[OpenWRT: Setup OLSR via Web]] '''RECOMMENDED'''
			* [[OLSR - di OpenWRT]]
			* [[OpenWRT: 3G modem]]
			* [[OpenWRT: 3G modem dengan usb_modeswitch]]
			* [[OpenWRT: Build Firmware dengan 3G Modem Support]]
			* [[OpenWRT: Setup Firewall]]
			* [[OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI]]
			* [[OpenWRT: OLSR nameservice plugin]]
			* [[OpenWRT: VLAN]]
			* [[OpenWRT: Multcast Forwarding]]

			===UBNT===

			* [[UBNT]]
			* [[UBNT: Teknik Recovery]]
			* [[UBNT: Upload Firmware]]
			* [[UBNT: Rebuild Firmware]]
			* [[UBNT: firmware dengan OLSR]]25
			* [[UBNT: openwrt]]
			* [[UBNT: olsr dengan openwrt]]
			* [[UBNT: olsr dengan kamikaze openwrt]]
			* [[UBNT: olsr dengan backfire openwrt]]
			* [[UBNT: UniFi]]
			* [[UBNT: UniFi Konfigurasi Awal]]
			* [[UBNT: UniFi Manajemen HotSpot]]
			* [[UBNT: OLSR Pembuatan Firmware]]
			* [[UBNT: OLSR Konfigurasi]]
			* [[OLSR - di UBNT]]
			* [[OLSR - di Ubuntu]]
			* [[OpenWRT]]
			* [[OLSR: NAT di UBNT dengan OLSR]]

Onnowpurbo at 06:07, 7 September 2014

2014-09-07T06:07:00Z

@@ Line 2: / Line 2: @@
-I'm testing the olsr 6and4 configuration.
+ /etc/config/olsrd
-I'm using OpenWRT 8.09 branch with latest packages as 19/03/09
+Misalnya, sebagai berikut
 ==Referensi==
 * https://dev.openwrt.org/ticket/4803

Onnowpurbo: New page: Sumber: https://dev.openwrt.org/ticket/4803 I'm testing the olsr 6and4 configuration. I'm using OpenWRT 8.09 branch with latest packages as 19/03/09 Looks like there is a bug when the...

2014-09-06T13:59:43Z

New page: Sumber: https://dev.openwrt.org/ticket/4803 I'm testing the olsr 6and4 configuration. I'm using OpenWRT 8.09 branch with latest packages as 19/03/09 Looks like there is a bug when the...

New page

Sumber: https://dev.openwrt.org/ticket/4803

I'm testing the olsr 6and4 configuration.

I'm using OpenWRT 8.09 branch with latest packages as 19/03/09

Looks like there is a bug when the configuration has HNA entries. The
problem is that both the generated /var/etc/olsrd.conf and
/var/etc/olsrd.conf.ipv4 contain hna4 and hna6 entries.

If you have a hna4 entry this will result in the IPv6 olsr daemon not
working, with the following error printed:

IPv4 addresses can only be used if "IpVersion" == 4
No interfaces configured!
Bad configuration!
No interfaces detected! This might be intentional, but it also might
mean that your configuration is fubar.
I will continue after 5 seconds...

If you have a hna6 entry this will result in the IPv4 olsr daemon not working.

IPv6 addresses can only be used if "IpVersion" == 6
No interfaces configured!
Bad configuration!
No interfaces detected! This might be intentional, but it also might
mean that your configuration is fubar.
I will continue after 5 seconds...

If you have both hna4 and hna6 entries this will result in both IPv4
and IPv6 olsr not working.

The not working olsr will keep running but with no interface configured.

To solve the problem you should have only hna4 entries in
/var/etc/olsrd.conf.ipv4 and only hna6 entries in /var/etc/olsrd.conf

Here is my uci configuration. Let me know if you can reproduce the bug.

config olsrd
# uncomment the following line to use a custom config file instead:
#option config_file '/etc/olsrd.conf'

option IpVersion '6and4'

config Interface
list interface 'ninuxif'

config 'Hna4'
option 'netaddr' '192.168.1.0'
option 'netmask' '255.255.255.0'

config 'Hna6'
option 'netaddr' '2002::'
option 'prefix' '64'

==Referensi==

* https://dev.openwrt.org/ticket/4803