IPv6 AutoConfiguration: Stateless auto-configuration: Difference between revisions

From OnnoCenterWiki
Jump to navigationJump to search
← Older edit
Onnowpurbo (talk | contribs)
69,477 edits
Onnowpurbo (talk | contribs)
69,477 edits
No edit summary
Onnowpurbo (talk | contribs)
69,477 edits
No edit summary
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
16.1. Stateless auto-configuration
Di dukung dan terlihat dari address link-local yang di berikan sesudah interface IPv6 di aktifkan.


Is supported and seen on the assigned link-local address after an IPv6-enabled interface is up.
Contoh:


Example:
# ip -6 addr show dev eth0 scope link


# ip -6 addr show dev eth0 scope link
Hasilnya kira-kira,


  2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qlen1000
  2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qlen 1000
     inet6 fe80::211:d8ff:fe6b:f0f5/64 scope link
     inet6 fe80::62a4:4cff:fe75:a6a0/64 scope link  
         valid_lft forever preferred_lft forever
         valid_lft forever preferred_lft forever
==Pranala Menarik==
* [[IPv6]]

Latest revision as of 05:32, 22 September 2018

Di dukung dan terlihat dari address link-local yang di berikan sesudah interface IPv6 di aktifkan.

Contoh: 

# ip -6 addr show dev eth0 scope link

Hasilnya kira-kira, 

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qlen 1000
    inet6 fe80::62a4:4cff:fe75:a6a0/64 scope link 
       valid_lft forever preferred_lft forever


Pranala Menarik

Retrieved from "https://lms.onnocenter.or.id/wiki/index.php?title=IPv6_AutoConfiguration:_Stateless_auto-configuration&oldid=51740"