IPv6 AutoConfiguration: Stateless auto-configuration: Difference between revisions
From OnnoCenterWiki
Jump to navigationJump to search
Onnowpurbo (talk | contribs) New page: 16.1. Stateless auto-configuration Is supported and seen on the assigned link-local address after an IPv6-enabled interface is up. Example: # ip -6 addr show dev eth0 scope link 2: eth0... |
Onnowpurbo (talk | contribs) No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Di dukung dan terlihat dari address link-local yang di berikan sesudah interface IPv6 di aktifkan. | |||
Contoh: | |||
# ip -6 addr show dev eth0 scope link | |||
Hasilnya kira-kira, | |||
2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 | |||
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qlen 1000 | |||
inet6 fe80::62a4:4cff:fe75:a6a0/64 scope link | |||
valid_lft forever preferred_lft forever | |||
==Pranala Menarik== | |||
* [[IPv6]] | |||
Latest revision as of 05:32, 22 September 2018
Di dukung dan terlihat dari address link-local yang di berikan sesudah interface IPv6 di aktifkan.
Contoh:
# ip -6 addr show dev eth0 scope link
Hasilnya kira-kira,
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qlen 1000
inet6 fe80::62a4:4cff:fe75:a6a0/64 scope link
valid_lft forever preferred_lft forever
